Dell N1100-ON, Reference Manual

Page: 594 / 2332

Layer 2 Switching Commands
594
Syntax
show vpc consistency-features { global | interface port-channel-number }
• port-channel-number—A valid port-channel identifier.
Default Configuration
There is no default configuration for this command.
Command Modes
Privileged Exec mode and above
User Guidelines
There are no user guidelines for this command.
show vpc peer-keepalive
Use the show vpc peer-keepalive command to display the peer MLAG
switch’s IP address used by the Dual Control Plane Detection Protocol. The
port used for the Dual Control Plane Detection Protocol is shown, as well as if
peer detection is enabled or not. If enabled, the detection status is displayed.
Syntax
show vpc peer-keepalive
Default Configuration
There is no default configuration for this command.
Command Modes
Privileged Exec mode and above
User Guidelines
A VPC domain ID must be configured for this command to display the
keepalive status.
Example
(Switching) # show vpc peer-keepalive