Dell N1100-ON, Reference Manual

Page: 583 / 2332

Layer 2 Switching Commands
583
Syntax
peer detection interval interval-msecs timeout timeout-msecs
no peer detection interval
• interval-msecs—The peer keepalive timeout in seconds. The range is 200–
4000 milliseconds.
• timeout-msecs—The peer timeout value in milliseconds. The range is
700–14000 milliseconds.
Default Configuration
The default transmission interval is 1000 milliseconds. The default reception
timeout is 3500 milliseconds.
Command Modes
VPC Domain mode
User Guidelines
This command configures the DCPDP transmission and timeout values. If an
MLAG switch does not receive DCPDP messages from the peer for the
configured timeout value, it takes the decision to transition its role (if
required).
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-vpc 1)#peer detection interval 750 timeout 3000
peer-keepalive destination
Use the peer-keepalive destination command to enable the Dual Control
Plane Detection Protocol with the configured IP address of the peer MLAG,
the local source address and the peer timeout value. The UDP port on which
the MLAG switch listens to the Dual Control Plane Detection Protocol
messages is also configurable with this command.
Use the
no form of the command to return the configuration to the default.