Dell N1100-ON, Reference Manual

Page: 2084 / 2332

Switch Management Commands
2084
Command Mode
Global Configuration mode
User Guidelines
The source interface must have an assigned IP address (either manually or via
another method such as DHCP). Use the show sflow source-interface
command to display the assigned source interface. This command is not
supported on Dell EMC N1100-ON switches. Dell EMC N1100-ON switches
support configuration of a single IP address in interface vlan configuration
mode. That IP address is used as the source interface address for this
function.
The out-of-band parameter is only available on switches so equipped.
Example
console#conf
console(config)#interface vlan 1
console(config-if-vlan1)#ip address dhcp
console(config-if-vlan1)#exit
console(config)#sflow source-interface vlan 1
show sflow agent
Use the show sflow agent command to display the sflow agent information.
Syntax
show sflow agent
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
The following fields are displayed: