Dell N1100-ON, Reference Manual

Page: 1818 / 2332

Layer 3 Routing Commands
1818
route. By default no routes are tracked. If we specify just the route to be
tracked without specifying the optional parameter, then the default priority
will be set.
Use the
no form of this command to remove the route from the tracked list or
to restore the priority decrement to its default. When removing a tracked IP
route from the tracked list, priority should be incremented by the decrement
value if the route is not reachable.
Syntax
vrrp group track ip route ip-address/prefix-length [ decrement priority]
no vrrp group track ip route ip-address/prefix-length
•
group
—
The virtual router identifier. (Range: 1–255).
•
ip-address/prefix-length
—
Specifies the route to be tracked.
•
priority
—
Priority decrement value for the tracked route. (Range: 1–254).
Default Configuration
There are no routes tracked by default.
The default decrement priority is 10.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example adds the route 2.2.2.0/24 to the virtual router tracked
list (with a priority decrement value of 20).
console(config-if-vlan10)#vrrp 1 track ip route 2.2.2.0/24 decrement 20
show vrrp
Use the show vrrp command in User Exec or Privileged Exec mode to display
the global VRRP configuration and status as well as the brief or detailed
status of one or all VRRP groups.