Dell N1100-ON, Reference Manual

Page: 1723 / 2332

Layer 3 Routing Commands
1723
area stub no-summary
Use the area stub no-summary command in Router OSPFv3 Configuration
mode disable the import of Summary LSAs for the stub area identified by
area-id.
Syntax
area area-id stub no-summary
no area area-id stub no-summary
• area-id — Valid OSPFv3 area identifier.
• so-summary — Disable the import of Summary LSAs for the stub area
identified by area-id.
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example prevents Summary LSAs from being advertised into
the area 1 NSSA.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 stub no-summary
area virtual-link
Use the area virtual-link command in Router OSPFv3 Configuration mode
to create the OSPF virtual interface for the specified area-id and neighbor
router. If the area has not been previously created, this command creates the
area and then applies the virtual-link parameters. To remove the link, use the
no form of the command. Use the optional parameters to configure dead-
interval, hello-interval, retransmit-interval and transmit-delay.