Dell N1100-ON, Reference Manual

Page: 1642 / 2332

Layer 3 Routing Commands
1642
area virtual-link hello-interval
Use the area virtual-link hello-interval command in Router OSPF
Configuration mode to configure the hello interval for the OSPF virtual
interface on the virtual interface identified by the area ID and neighbor ID.
Use the no form of the command to return the hello interval to the default
value.
Syntax
area area-id virtual-link neighbor-id hello-interval seconds
no area area-id virtual-link neighbor-id hello-interval
• area-id — Identifies the OSPF area to configure. (Range: IP address or
decimal from 0–4294967295)
• neighbor-id — Identifies the Router ID of the neighbor.
• seconds — Number of seconds to wait before sending hello packets to the
OSPF virtual interface. (Range: 1–65535)
Default Configuration
10 seconds is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures a 50-second wait interval.
console(config-router)#area 10 virtual-link 192.168.2.2 hello-interval 50