Dell N1100-ON, Reference Manual

Page: 1607 / 2332

Layer 3 Routing Commands
1607
Default Configuration
There are no static RP addresses configured by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pim rp-address 2001::1 ff1e::/64
ipv6 pim rp-candidate
Use the ipv6 pim rp-candidate command to configure the router to advertise
itself as a PIM candidate rendezvous point (RP) to the bootstrap router
(BSR). Use the
no
form of this command to disable the router from
advertising itself as a PIM candidate rendezvous point (RP) to the bootstrap
router (BSR).
Syntax
ipv6 pim rp-candidate vlan vlan-id group-address/prefixlength [interval
c_rp_interval ]
no ipv6 pim rp-candidate vlan vlan-id
• vlan-id — A valid VLAN ID value.
• group-address — The group address to display.
• prefixlength — This parameter specifies the prefix length of the IP address
for the media gateway. (Range: 1–128)
• c_rp_interval—The Candidate RP advertisement interval (range 1-16383
seconds, default 60 seconds).
Default Configuration
The router does not advertise itself as a PIM candidate rendezvous point by
default.