Dell N1100-ON, Reference Manual

Page: 1603 / 2332

Layer 3 Routing Commands
1603
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pim bsr-candidate vlan 9 10 34
ipv6 pim dense-mode
Use the ipv6 pim dense-mode command in Global configuration mode to
administratively configure PIM dense mode for IPv6 multicast routing. This
command also enables MLD. Use the no form of this command to disable
PIM and MLD. This command does not affect ip multicast-routing .
Syntax
ipv6 pim dense-mode
no ipv6 pim
Default Configuration
PIM dense mode is disabled by default.
Command Mode
Global Configuration mode
User Guidelines
Only one of sparse or dense mode can be configured on a router. DVMRP
must be disabled before enabling PIM.
Example
console(config)#ipv6 pim dense
ipv6 pim dr-priority
Use the ipv6 pim dr-priority command to set the priority value for which a
router is elected as the designated router (DR). Use the
no
form of this
command to set the priority to the default.