Dell N1100-ON, Reference Manual

Page: 1524 / 2332

Layer 3 Routing Commands
1524
ipv6 nd ra hop-limit unspecified
Use the ipv6 nd ra hop-limit unspecified command to configure the hop
limit sent in router alert messages. Use the no form of the command to send
the default hop limit of 64.
Syntax
ipv6 nd ra hop-limit unspecified
no ipv6 nd ra hop-limit unspecified
Default Configuration
The default TTL is 64.
Command Mode
Interface (VLAN) Configuration
User Guidelines
The TTL sent in router advertisements and neighbor discovery packets may
be configured using the Global Configuration command ipv6 hop-limit .
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd ra hop-limit unspecified
ipv6 nd managed-config-flag
Use the ipv6 nd managed-config-flag command in Interface Configuration
mode to set the “managed address configuration” flag in router
advertisements. When the value is true,
end nodes use DHCPv6. When the value is false, end nodes automatically
configure addresses.