Dell N1100-ON, Reference Manual

Page: 1515 / 2332

Layer 3 Routing Commands
1515
User Guidelines
This command has no user guidelines.
Example
The following example configures an IPv6 address and enables IPv6
processing.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 address 2020:1::1/64
ipv6 enable
Use the ipv6 enable command in VLAN Interface Configuration mode to
enable IPv6 routing on an interface (including tunnel and loopback
interfaces) that has not been configured with an explicit IPv6 address.
Command execution automatically configures the interface with a link-local
address. The command is not required if an IPv6 global address is configured
on the interface.
Syntax
ipv6 enable
no ipv6 enable
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables IPv6 routing, which has not been configured
with an explicit IPv6 address.
console(config)#vlan 15
console(config-vlan)#interface vlan 15