Dell N1100-ON, Reference Manual

Page: 1412 / 2332

Layer 3 Routing Commands
1412
User Guidelines
When used in a route map applied to UPDATE messages received from a
neighbor, the command sets the next hop address for matching IPv6 routes
received from the neighbor. When used in a route map applied to UPDATE
messages sent to a neighbor, the command sets the next hop address for
matching IPv6 routes sent to the neighbor. If the address is a link local
address, the address is assumed to be on the interface where the UPDATE is
sent or received. If the command specifies a global IPv6 address, the address is
not required to be on a local subnet.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(route-map)#set ipv6 next-hop FE80::0202:B3FF:FE1E:8329
set local-preference
To set the local preference of specific BGP routes, use the set local-preference
command in route-map configuration mode. To remove a set command from
a route map, use the no form of this command.
Syntax
set local-preference value
no set local-preference value
• value — A local preference value, from 0 to 4,294,967,295 (any 32 bit
integer).
Default Configuration
There is no default configuration for this command.
Command Mode
Route Map Configuration