Dell N1100-ON, Reference Manual

Page: 1248 / 2332

Layer 3 Routing Commands
1248
Syntax
enable
no enable
Default Configuration
By default, BGP is enabled once the administrator has specified the local AS
number with the router bgp command and configured a router id with bgp
router-id .
Command Mode
BGP Router Configuration mode
User Guidelines
When disabling BGP using no enable , BGP retains its configuration. The no
router bgp command resets all BGP configuration to default values.
When BGP is administratively disabled, BGP sends a NOTIFICATION
message to each peer with a Cease error code.
The
no enable command persists in the running-config (and startup-config)
only when a router-id has assigned using the bgp router-id command. If no
router-id has been assigned, the administrative state will not appear in the
running-config or in the startup-config.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router)#enable
ip as-path access-list
Use this command to create an AS path access list. To delete an AS path
access list, use the no form of this command.
Syntax
ip as-path access-list as-path-list-number { permit | deny } regexp