Dell N1100-ON, Reference Manual

Page: 1056 / 2332

Security Commands
1056
Default Configuration
The default value is 0.
Command Mode
Global Configuration
User Guidelines
This command has no user guidelines.
Example
console(config)#passwords strength max-limit consecutive-characters 3
passwords strength max-limit repeated-
characters
Use this command to enforce a maximum repeated characters that a
password should contain. If password has repetition of characters more than
the configured max-limit, it fails to configure. The valid range is 0-15. The
default is 0. A maximum of 0 means again disabling the restriction. Use the
no form of this command to reset the maximum repeated characters to the
default value.
Syntax
passwords strength max-limit repeated-characters 0-15
no passwords strength max-limit repeated-characters
Default Configuration
The default value is 0.
Command Mode
Global Configuration
User Guidelines
This command has no user guidelines.