Installing the display assembly
1
Place the base of the computer on a flat surface.
2
Align the display assembly with the display hinge screw holders.
3
Replace the 4 (M2.5 x 4.0) screws to secure the display assembly.
4
Close the display assembly and flip the computer.
5
Connect the cables:
a G-sensor and eDP cable
b Place the eDP bracket on the eDP cable and replace the 2 (M2 x 2) screw on the bracket.
c IR camera and touch screen cables
6
Route the antenna cables through the routing clips
7
Affix the tapes to secure the antenna cables to the system board.
8
Install the:
a
b
c
d
e
f
NOTE:
To install both cards if equipped.
9
Follow the procedure in
After working inside your computer
.
System Board
26
Removing and installing components