Installing the NVMe SSD
1
Insert the NVMe SSD card into the connector.
2
Install the thermal bracket over the SSD card.
3
Tighten the M2.0 x 3.0 screws to secure the SSD thermal bracket.
4
Install the:
a
NOTE:
If you have not removed the battery, you must connect the battery cable to the system board.
b
c
5
Follow the procedure in
After working inside your computer
.
WLAN card
Removing the WLAN card
1
Follow the procedure in
Before working inside your computer
.
2
Remove:
a
b
c
NOTE:
You need not remove battery, instead you can disconnect the battery cable from the system board.
3
To remove the WLAN card:
a Remove the M2.0 x 3.0 screw that secures the metal bracket to the WLAN card [1].
b Lift the metal bracket [2].
Removing and installing components
13
Summary of Contents for Latitude 7389
