How to run M-BIST
NOTE:
M-BIST must be initiated on the system from a power-off state either connected to AC power or with battery
only.
1. Press and hold both the
M
key on the keyboard and the
power button
to initiate M-BIST.
2. With both the
M
key and the
power button
held down, the battery indicator LED may exhibit two states:
a. OFF: No fault detected with the system board
b. AMBER: Indicates a problem with the system board
RTC reset and Flea power release
About this task
Flea power is the residual static electricity that remains on the computer even after it has been powered off and the battery has been
disconnected from the system board. The following procedure provides the instructions on how to release the flea power:
Steps
1. Turn off your computer.
2. Remove the
NOTE:
The battery must be disconnected from the system board, see Step 2 in
3. Press and hold the power button for 15 seconds to drain the flea power.
4. Install the
.
5. Turn on your computer.
NOTE:
Performing a flea power also reset the RTC of the system. Update the system time and date at first startup.
Troubleshooting
61
Summary of Contents for Latitude 7310
