3. Remove the two M2x2 screws securing the eDP bracket and remove it from the system board.
4. Disconnect the following cables from the system board :
•
IR camera cable (for systems shipped with IR camera)
•
Touchscreen cable (for systems shipped with touchscreen)
•
Display cable
•
Sensor daughterboard cable
•
Touchpad FFC
•
Battery LED FPC
•
USH daughterboard FFC
5. Remove the three M2x5 screws securing the Type-C USB bracket to the system board.
6. Remove the USB Type-C bracket from the system board.
7. Remove the single M2x2.5 screw securing the system board to the palmrest assembly.
8. Remove the system board from the system.
Installing the system board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the system board and provide a visual representation of the installation procedure.
42
Removing and installing components
Summary of Contents for Latitude 7310
