Dell Latitude 7310, Service Manual

Page: 33 / 63

Steps
1. Align and place the display assembly at an convenient angle and replace the two M2.5x4 screws securing the hinges of the display
assembly to the palmrest.
2. Connect the eDP cable, camera cable and touch sensor cable to the system board.
NOTE: The display cable and sensor daughter board cable are bundled together with tape. Connect the display cable
first followed by sensor daughter board cable.
3. Replace the eDP bracket on the eDP connector on the system board and replace the two M2x2 screws securing it to the system
board.
Next steps
If you are replacing a component, remove the existing component before performing the installation procedure.
1. Install the:
a. Base cover
2. Follow the procedure in After working inside your computer .
Speakers
Removing the speaker
Prerequisites
1. Follow the procedure in Before working inside your computer .
2. Remove the:
a. Base cover
b. Battery
3. Disconnect the WWAN antennae cables .
About this task
The following images indicate the location of the speaker and provide a visual representation of the removal procedure.
Removing and installing components 33