Dell Latitude 5501, Service Manual

Page: 79 / 97

Pași
1. Locate the display cable, touchscreen cable and display hinges on your computer.
2. Peel back the tape and disconnect the touchscreen cable.
3. Remove the two (M2x3) screws that secure the EDP metal bracket to the computer.
4. Peel the tape that secures the display cable to the system board.
5. Open the latch and disconnect the display cable from the system board.
6. Unroute the WLAN and WWAN cables from the retention clips.
7. Remove the six (M2.5x4) screws that secure the display hinges to the chassis of your computer.
8. Open the display hinges at an angle of 90 degrees and slightly open the display.
9. Remove the palm-rest and keyboard assembly off the display assembly.
Installing the display assembly
Cerințe preliminare
If you are replacing a component, remove the existing component before performing the installation procedure.
Despre această sarcină
The figure indicates the location of the component and provides a visual representation of the installation procedure.
Dezasamblarea și reasamblarea 79