Dell Latitude 5501, Service Manual

Page: 53 / 97

2. Open the latch and disconnect the LED board cable from the system board.
3. Peel back the LED board cable.
NOTIFICARE : The LED board cable is secured to the computer by an adhesive strip.
4. Remove the single (M2x3) screw that secures the LED board to the computer.
5. Lift the LED board out of the computer.
Installing the LED board
Cerințe preliminare
If you are replacing a component, remove the existing component before performing the installation procedure.
Despre această sarcină
The figure indicates the location of the LED board and provides a visual representation of the installation procedure.
Pași
1. Locate the LED board slot on your computer.
2. Align and place the LED board on the slot on your computer.
3. Install the single (M2x3) screw that secures the LED board to the computer.
4. Adhere the LED board cable to the adhesive strip on the computer.
5. Connect the LED board cable to the connector on the system board.
Dezasamblarea și reasamblarea 53