About this task
The figure indicates the location of the power button with fingerprint reader and provides a visual representation of the installation
procedure.
Steps
1. Using the alignment post, place the power button with fingerprint reader on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x2.5) to secure the power button with optional fingerprint reader to the palm-rest and keyboard
assembly.
3. Plug the I/O cable into the connector on palm-rest and keyboard assembly and close the latch.
4. Plug the fingerprint reader cable into the connector on palm-rest and keyboard assembly.
Next steps
1. Install the
2. Install the
3. Install the
4. Install the
5. Install the
.
6. Install the
.
7. Follow the procedure in
after working inside your computer
.
DC-in port
Removing the DC-in port - UMA
Prerequisites
1. Follow the procedure in
before working inside your computer
2. Remove the
3. Remove the
.
Lahtivõtmine ja kokkupanek
63
Summary of Contents for Latitude 5401
