Next steps
1. Install the
.
2. Install the
.
3. Follow the procedure in
after working inside your computer
.
Jahutusradiaator
Removing the heat sink - UMA
NOTE:
The heat sink type in your computer varies depending on the configuration ordered.
Prerequisites
1. Follow the procedure in
before working inside your computer
2. Remove the
3. Remove the
.
4. Remove the
.
About this task
The figure indicates the location of the heat sink and provides a visual representation of the removal procedure.
Steps
1. In sequential order (as indicated on the heat sink), loosen the four captive screws that secure the heat sink to the system board.
2. Lift and remove the heat sink off the system board.
Installing the heat sink - UMA
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Lahtivõtmine ja kokkupanek
49
Summary of Contents for Latitude 5401
