Dell Latitude 5320, Service Manual

Page: 51 / 116

5. Open the latch and disconnect the display eDP cable its connector on the system board.
6. Remove the single (M2x4) screw that secures the display cable bracket to the system board to release the display cable.
7. Remove the two screws (M2.5x4) that secure the left-display hinge to the system board.
8. Remove the two screws (M2.5x4) that secure the right-display hinge to the system board.
9. Open the display hinges at an angle of 90 degrees.
10. Gently slide the palm-rest and keyboard assembly off the display assembly carefully.
Installing the display assembly (laptop)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display assembly and provides a visual representation of the installation
procedure.
Removing and installing components 51