b
3
To remove the SSD module:
a Remove the M2.0 x 2.5 screw securing the SSD shield [1].
b Lift the SSD shield away from the tablet [2].
c Slide and lift the SSD module from the slot on the tablet [3].
NOTE:
Ensure NOT to lift the SSD card by an angle more than 15°.
Installing SSD module
1
Insert the SSD module into the connector on the system board.
2
Install the SSD shield on the SSD module.
CAUTION:
Align the five clips heads into the system board clips holes, to install the shield properly. Ensure to insert the clips
with caution, as the clips are small and delicate. Mishandling damages the clips head and needs replacing the shield.
3
Replace the M2.0 x 2.5 screw to secure SSD shield.
NOTE:
Align the shield carefully to avoid damage to the clips heads.
4
Install the:
a
b
Micro-SIM card is installed only on tablets shipped with WWAN module.
5
Follow the procedure in
after working inside your tablet
Removing and installing components
15
Summary of Contents for Latitude 5290 2-in-1
Page 1: ...Latitude 5290 2 in 1 Owner s Manual Regulatory Model T17G Regulatory Type T17G002 ...
Page 45: ...Disk driver Figure 4 Disk driver Technology and components 45 ...
Page 47: ...Storage controller drivers Figure 6 Storage controllers Technology and components 47 ...
Page 82: ...82 Software ...
