Steps
1. Align the notch on the solid-state drive with the tab on the M.2 card connector.
2. Slide the solid-state drive into the M.2 card connector on the system board.
3. Replace the screw (M2x3) that secures the solid-state drive to the system board.
4. Close the solid-state drive mylar sheet to cover the solid-state drive.
NOTE:
There is a protective mylar sheet covering the solid-state drive. This mylar sheet must be closed after the
installation procedure.
Next steps
1. Install the
.
2. Exit the
.
3. Install the
.
After working inside your computer
.
Speakers
Removing the speakers
Prerequisites
before working inside your computer
.
2. Remove the
3. Enter the
.
4. Remove the
.
About this task
The following image indicates the location of the speakers and provides a visual representation of the removal procedure.
Removing and installing components
21
