5. Route the display cable through the routing guides on the palm-rest and antenna assembly and connect the display cable to the
system board.
6. Close the right display hinge.
7. Replace the three screws (M2.5x5) that secure the right display hinge to the I/O board.
Next steps
1. Install the
.
2. Follow the procedure in
After working inside your computer
.
Touchpad
Removing the touchpad
Prerequisites
1. Follow the procedure in
Before working inside your computer
.
2. Remove the
3. Remove the
.
About this task
The following image indicates the location of the touchpad and provides a visual representation of the removal procedure.
Steps
1. Remove the three (M2x3) screws that secure the touchpad bracket to the palm-rest and antenna assembly.
2. Lift the touchpad bracket off the palm-rest and antenna assembly.
3. Open the latch and disconnect the touchpad cable from the touchpad.
4. Peel the tape that secures the touchpad to the palm-rest and antenna assembly.
5. Remove the two (M1.6x2) screws that secure the touchpad to the palm-rest and antenna assembly.
6. Slide and lift the touchpad off the palm-rest and antenna assembly.
26
Removing and installing components
Summary of Contents for Inspiron 7791 2n1
Page 1: ...Inspiron 7791 2n1 Service Manual Regulatory Model P42E Regulatory Type P42E001 ...
Page 12: ...12 Removing and installing components ...
Page 34: ...34 Removing and installing components ...
Page 35: ...Removing and installing components 35 ...
