Steps
1. Align the notch on the WLAN card with the tab on the WLAN card slot and insert the WLAN card at an angle into the WLAN
card slot.
2. Connect the antenna cables to the WLAN card.
3. Align and place the WLAN card bracket on the WLAN card.
4. Replace the screw (M2x4) to secure the WLAN card bracket to the WLAN card.
Next steps
1. Install the
.
2. Install the
.
After working inside your computer
.
Solid-state drive
Removing the M.2 2280 solid-state drive
Prerequisites
Before working inside your computer
.
2. Remove the
.
3. Disconnect the
.
About this task
The figure indicates the location of the solid-state drive and provides a visual representation of the removal procedure.
NOTE:
The computer is shipped with solid-state drive shield only if the solid-state drive capacity is more than 512 GB.
22
Removing and installing components
Summary of Contents for Inspiron 7590
Page 1: ...Inspiron 7590 Service Manual Regulatory Model P83F Regulatory Type P83F001 July 2021 Rev A05 ...
Page 54: ...54 Removing and installing components ...
Page 55: ...Removing and installing components 55 ...
Page 57: ...Removing and installing components 57 ...
