Steps
1. Place the power-adapter port, along with its cable, into the slot on the palm-rest and keyboard assembly.
2. Route the power-adapter port cable through the routing guide on the palm-rest and keyboard assembly.
3. Replace the screw (M2x3) that secures the power-adapter port to the palm-rest and keyboard assembly.
4. Connect the power-adapter port cable to the system board.
5. Close the right display hinge.
6. Replace the two screws (M2x3.5) that secure the right display-hinge to the system board and palm-rest and keyboard
assembly.
7. Replace the screw (M2.5x5) that secures the right display-hinge to the system board and palm-rest and keyboard assembly.
Next steps
1. Install the
.
After working inside your computer
.
Touchpad
Removing the touchpad
Prerequisites
Before working inside your computer
.
2. Remove the
.
3. Remove the
.
About this task
The following image indicates the location of the touchpad and provides a visual representation of the removal procedure.
Removing and installing components
27
