Steps
1. Using the alignment post, place the power button with optional fingerprint reader on the palm-rest and keyboard assembly.
2. Replace the single screw (M1.6x2.5) to secure the power button with optional fingerprint reader to the palm-rest and keyboard
assembly.
3. Replace the bracket and the single screw (M1.6x2.5).
4. Plug the fingerprint reader cable into the fingerprint connector on palm-rest and keyboard assembly.
5. Plug the fingerprint-reader board cable, if installed, into the fingerprint-reader board and close the latch.
6. Replace the transparent adhesive cover back.
Next steps
1. Install the
2. Install the
.
3. Install the
.
4. Follow the procedure in
after working inside your computer
.
DC-in port
Removing the DC-in port
Prerequisites
1. Follow the procedure in
before working inside your computer
2. Remove the
About this task
The figure indicates the location of the DC-in port and provides a visual representation of the removal procedure.
46
Removing and installing components
