Steps
1. Using the alignment post, slide and place the touchpad along with the bracket into the slot on the palm-rest assembly.
2. Adhere the touchpad cable from the touchpad.
3. Replace the four (M1.6x2) screws that secure the touchpad bracket to the palm-rest assembly.
4. Slide the touchpad cable into its connector on the touchpad and close the latch to secure the cable.
Next steps
1. Install the
.
2. Install the
.
3. Follow the procedure in
after working inside your computer
.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in
before working inside your computer
2. Remove the
3. Remove the
.
About this task
The following image indicates the location of display assembly and provides a visual representation of the removal procedure.
38
Removing and installing components
Summary of Contents for Inspiron 7490 P115G
Page 1: ...Inspiron 7490 Service Manual Regulatory Model P115G Regulatory Type P115G001 ...
Page 49: ...Removing and installing components 49 ...
Page 50: ...50 Removing and installing components ...
Page 53: ...Removing and installing components 53 ...
