About this task
The following image indicates the location of the base cover and provides a visual representation of the installation procedure.
Steps
1. Place and align the screw holes on the heat sink with the screw holes on the system board.
2. In sequential order (1>2>3>4>5) as indicated on the heat sink, replace the five screws (M2x3) that secure the heat sink to the system
board.
3. Place the shield on the heat sink.
4. Adhere the tapes that secure the WWAN antenna cables to the shield on the heat sink.
5. Adhere the tapes that secure the I/O-board cable to the shield on the heat sink.
6. Adhere the tapes that secure the fan to the heat sink.
Next steps
1. Install the
.
2. Install the
.
3. Follow the procedure in
After working inside your computer
.
Removing the heatsink (on computers shipped with
integrated graphics card)
Prerequisites
1. Follow the procedure in
before working inside your computer
2. Remove the
3. Remove the
.
About this task
The following image indicates the location of the base cover and provides a visual representation of the installation procedure.
28
Removing and installing components
Summary of Contents for Inspiron 7490 P115G
Page 1: ...Inspiron 7490 Service Manual Regulatory Model P115G Regulatory Type P115G001 ...
Page 49: ...Removing and installing components 49 ...
Page 50: ...50 Removing and installing components ...
Page 53: ...Removing and installing components 53 ...
