3. Follow the procedure in
After working inside your computer
.
Heat sink
Removing the heatsink (on computers shipped with
discrete graphics card)
Prerequisites
1. Follow the procedure in
before working inside your computer
2. Remove the
3. Remove the
.
About this task
The following image indicates the location of the base cover and provides a visual representation of the installation procedure.
Steps
1. Peel the tapes that secure the fan to the fan to the heat sink.
2. In the reverse sequential order (5>4>3>2>1) as indicated on the heat sink, remove the five screws (M2x3) that secure the heat sink to
the system board.
3. Lift the heat sink off the system board.
Installing the heat sink (on computers shipped with
discrete graphics card)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
27
Summary of Contents for Inspiron 7490 P115G
Page 1: ...Inspiron 7490 Service Manual Regulatory Model P115G Regulatory Type P115G001 ...
Page 49: ...Removing and installing components 49 ...
Page 50: ...50 Removing and installing components ...
Page 53: ...Removing and installing components 53 ...
