Installing the M.2 Solid State Drive - SSD
NOTE:
Before installing SSD card, ensure that the battery is fully charged or the power cable is plugged in.
1
Place the SSD clip on the laptop.
2
Tighten the M2.0x3.0 screw that secures SSD clip to the laptop.
3
Insert the SSD into the socket on the laptop.
4
Place the SSD bracket and tighten the M2.0x3.0 screw (2) to secure the SSD to the laptop.
5
Install the:
a
b
6
Follow the procedure in
After working inside your computer
.
Hard drive
Removing hard drive
1
Follow the procedure in
Before working inside your computer
.
2
Remove the
3
Do not remove the battery, instead disconnect the battery cable from the system board.
4
To remove the hard drive:
a Disconnect the hard drive cable from the connector on the system board [1].
Removing and installing components
17
