NOTE:
The following steps are applicable only to computers that are shipped with optical drive.
7. Press down on the latch to connect the optical-drive connector board cable to the optical-drive connector board.
8. Press down on the latch to connect the optical-drive connector board cable to the system board.
Post-requisites
1. Replace the
2. Replace the
.
3. Replace the
(applicable only to computers shipped with optical drive).
រន្ធអាោរ់ទ័រថាមរល
ការលោះរន្ធអាោរ់ទ័រថាមរល
ចំណាំ
មុននឹងលធ្វប្ការលៅខាងក្នុងកុំរ្យទទ័រររស់អ្នក
សូមអានរ័ត៌មានសុែត្ថិភារដែលមកពាមួយនឹងកុំរ្យទទ័រររស់អ្នក
និងអនុែតតាតាមជំហាននានាលៅក្នុង
មុននឹងលធ្វប្ការលៅខាងក្នុងកុំរ្យទទ័រររស់អ្នក
រនាទារ់រីលធ្វប្ការលៅខាងក្នុងកុំរ្យទទ័រររស់អ្នក
សូមអនុែតតាតាមការដណនាំលៅក្នុង
សប្មារ់រ័តមានរដន្ថម
សតាីរីការអនុែតតាប្រករលោយសុែត្ថិភាររំលុត
សូមលមប្លលរហទំរ័រ
ការអនុែតតាតាមរទរញញាតតាិ
តាមរយៈ
www.dell.com/regulatory_compliance
។
Prerequisites
1. Remove the
(applicable only to computers shipped with optical drive).
2. Remove the
3. Remove the
.
Procedure
1. Remove the three screws (M2.5x5) that secure the left hinge to the system board and palm-rest assembly.
2. Lift the left hinge.
3. Disconnect the power-adapter port cable from the system board.
4. Note the power-adapter port cable routing and remove it from the routing guides on the palm-rest and keyboard assembly.
5. Remove the screw (M2x2) that secures the power-adapter port to the palm-rest and keyboard assembly.
6. Lift the power-adapter port, along with its cable, off the palm-rest and keyboard assembly.
46
ការលោះ
និងែំលេប្ងសមាសភារនានា