Steps
1. Disconnect the battery cable from the system board.
NOTE:
This step is applicable only if the battery cable has not been disconnected.
2. Remove the six screws (M2x3) that secure the 6-cell battery to the palm-rest and keyboard assembly.
3. Lift the 6-cell battery off the palm-rest and keyboard assembly.
Installing the 6-cell battery (87 Wh)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE:
This procedures only applies if you are installing a 6-cell battery (87 Wh) into your computer.
The following image(s) indicate the location of the 6-cell battery (87 Wh) and provides a visual representation of the installation
procedure.
36
Removing and installing components
