Solid-state drive
Removing the 2230 solid-state drive
Prerequisites
Before working inside your computer
.
2. Remove the
.
About this task
NOTE:
This procedure applies only to computers shipped with an M.2 2230 solid-state drive installed.
NOTE:
The M.2 card installed will depend on the configuration ordered. Supported card configurations on the M.2 card slot:
●
M.2 2230 solid-state drive + M.2 2230 mounting bracket
●
M.2 2280 solid-state drive
The following image(s) indicate the location of the 2230 solid-state drive and provides a visual representation of the removal
procedure.
Steps
1. Peel the Mylar that secures the M.2 2230 solid-state drive to the M.2 slot on the system board.
2. Remove the screw (M2x2) that secures the M.2 2230 solid-state drive mounting bracket to the system board.
3. Slide and lift the M.2 2230 solid-state drive assembly off the system board.
4. Flip over the M.2 2230 solid-state drive assembly.
5. Remove the screw (M2x2) that secures the M.2 2230 solid-state drive to the mounting bracket.
6. Lift the M.2 2230 solid-state drive off the mounting bracket.
Installing the 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
18
Removing and installing components
