Steps
1. Align and place the I/O board under the left hinge assembly and on to the palm-rest and keyboard assembly.
2. Replace the two (M2x3) screws to secure the I/O daughter board to the palm-rest and keyboard assembly.
3. Replace the three (M2x3) screws to secure the I/O daughter board to the palm-rest and keyboard assembly.
4. Connect the fingerprint-reader board cable to the connector on the I/O board and close the latch, if applicable.
5. Connect the I/O-board power cable to the connector on the I/O board and close the latch.
Next steps
1. Install the
.
2. Exit
.
3. Install the
.
after working inside your computer
.
Touchpad
Removing the touchpad assembly
Prerequisites
before working inside your computer
.
2. Remove the
.
3. Remove the
.
4. Remove the
.
About this task
The following images indicate the location of the touchpad and provides a visual representation of the removal procedure.
Removing and installing components
47
