Importing foreign configuration using RACADM
To import foreign configuration:
racadm storage importconfig:<Controller FQDD>
For more information, see the
iDRAC RACADM Command Line Reference Guide
available at
dell.com/idracmanuals
.
Clearing foreign configuration
After moving a physical disk from one controller to another, you may find that the physical disk contains all or some portion of a
virtual disk (foreign configuration). You can identify whether a previously used physical disk contains a foreign configuration (virtual
disk) by checking the physical disk state. If the physical disk state is Foreign, then the physical disk contains all or some portion of a
virtual disk. You can clear or erase the virtual disk information from the newly attached physical disks.
The Clear Foreign Configuration operation permanently erases all data residing on the physical disks that are added to the controller.
If more than one foreign virtual disk is present, all the configurations are erased. You may prefer to import the virtual disk rather than
destroy the data. An initialization must be performed to remove foreign data. If you have an incomplete foreign configuration which
cannot be imported, you can use the Clearing Foreign Configuration option to erase the foreign data on the physical disks.
Clearing foreign configuration using web interface
To clear the foreign configuration:
1.
In the iDRAC web interface, go to
Overview
→
Storage
→
Controllers
→
Setup
.
The
Setup Controllers
page is displayed.
2.
In the
Foreign Configuration
section, from the
Controller
drop-down menu, select the controller for which you want to clear
the foreign configuration.
3.
From the
Apply Operation Mode
drop-down menu, select when you want to clear the data.
4.
Click
Clear
.
Based on the selected operation mode, the virtual disks residing on the physical disk is erased.
Clearing foreign configuration using RACADM
To clear foreign configuration:
racadm storage clearconfig:<Controller FQDD>
For more information, see the
iDRAC RACADM Command Line Reference Guide
available at
dell.com/idracmanuals
.
Resetting controller configuration
You can reset the configuration for a controller. This operation deletes virtual disk drives and unassigns all hot spares on the
controller. It does not erase any data other than removing the disks from the configuration. Reset configuration also does not
remove any foreign configurations. The real-time support of this feature is available only in PERC 9.1 firmware. Reset configuration
does not erase any data. You may recreate the exact same configuration without an initialize operation which may result in the data
being recovered. You must have server control privilege.
NOTE: Resetting the controller configuration does not remove a foreign configuration. To remove a foreign
configuration, perform clear configuration operation.
Resetting controller configuration using web interface
To reset the controller configuration:
1.
In the iDRAC Web interface, go to
Overview
→
Storage
→
Controllers
→
Troubleshooting
.
The
Controllers Troubleshooting
page is displayed.
2.
From the
Actions
drop-down menu, select
Reset Configuration
for one or more controllers.
3.
For each controller, from the
Apply Operation Mode
drop-down menu, select when you want to apply the settings.
4.
Click
Apply
.
208