Figure 59. Installing the 1.8-inch (x4) SSD backplane
1. hard drive or SSD backplane
2. hard drive or SSD backplane cable
3. release latch (2)
4. guide pin (3)
5. retention screw on the backplane cable connector (2)
6. connector on system board
Next steps
1. Install the hard drives or SSDs in their original locations.
2. Follow the procedure listed in the After working inside your system section.
Related References
Related tasks
on page 94
Removing the hard drive or SSD backplane
After working inside your system
on page 52
Installing the hard drive or SSD cage
on page 104
Installing a hard drive or SSD
Storage controller card
Your system includes a dedicated expansion card slot on the server module system board for a storage controller card that provides the
integrated storage subsystem for your system’s hard drives. The storage controller card supports SAS HDDs, SATA HDDs, and PCIe
SSDs.
NOTE:
The storage controller card is located underneath the hard drive bays.
Installing and removing server module components
109
