Steps
1. Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest and keyboard assembly
NOTE:
If the rubber grommets are pushed out of the speakers when removing the speakers, push them back in place
before replacing the speakers.
2. Connect the speaker cable to the system board and route the cable below the ethernet and audio board.
3. Adhere the speaker cable to the palm-rest and keyboard assembly.
4. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
NOTE:
Route the speaker cable below the ethernet and audio. Do not route the speaker cable over the solid-state drive
bracket.
Next steps
1. Install the
.
After working inside your computer
.
Touchpad
Removing the touchpad
Prerequisites
Before working inside your computer
.
2. Remove the
.
3. Remove the
.
About this task
The following image indicates the location of the touchpad and provides a visual representation of the removal procedure.
26
Removing and installing components