Dell Force10 TeraScale C Series, Reference Manual

Page: 794 / 1640

794 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Parameters
Command Modes EXEC
EXEC Privilege
Command
History
timers bgp
c e
Allows you to adjust the BGP network timers for all neighbors.
Syntax timers bgp keepalive holdtimer
To return to the default values, use the
no timers bgp
command.
Parameters
Defaults keepalive
= 60 seconds;
holdtimer
= 180 seconds
Command Modes
ROUTER BGP
Command
History
Related
Commands
regular-expression [ character ]
Enter a regular expression then use one or a combination of the
following characters to match:
• . = (period) any single character (including a white space)
•
*
= (asterisk) the sequences in a pattern (0 or more sequences)
• + = (plus) the sequences in a pattern (1 or more sequences)
• ? = (question mark) sequences in a pattern (either 0 or 1
sequences). You must enter an escape sequence (CTRL+v)
prior to entering the ? regular expression.
• [ ] = (brackets) a range of single-character patterns.
• ^ = (caret) the beginning of the input string. If the caret is
used at the beginning of a sequence or range, it matches on
everything BUT the characters specified.
• $ = (dollar sign) the end of the output string.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
keepalive
Enter the time interval in seconds between which the E-Series sends keepalive messages.
Range: 1 to 65535
Default: 60 seconds
holdtimer Enter the time interval in seconds which the E-Series waits since the last keepalive
message before declaring a BGP peer dead.
Range: 3 to 65535
Default: 180 seconds
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
neighbor timers Adjust BGP timers for a specific peer or peer group.