Dell Force10 TeraScale C Series, Reference Manual

Page: 458 / 1640

458 | Dynamic Host Configuration Protocol (DHCP)
www.dell.com | support.dell.com
clear ip dhcp
c s
Reset DHCP counters.
Syntax clear ip dhcp [binding {address} | conflict | server statistics]
Parameters
Command Mode EXEC Privilege
Default None
Command
History
Usage
Information
Entering <CR> after
clear ip dhcp binding
, clears all the IPs from the binding table.
client-identifier
c s
Identify the Microsoft clients using a special identifier rather than the hardware address.
Syntax client-identifier unique-identifier
Parameters
Command Mode DHCP
Default None
Command
History
Usage
Information
Microsoft clients require a client identifier instead of a hardware addresses. The client identifier is
formed by concatenating the media type and the MAC address of the client. Refer to the “Address
Resolution Protocol Parameters” section of RFC 1700—Assigned Numbers, for a list of media type
codes.
debug ip dhcp server
c s
Display FTOS debugging messages for DHCP.
Syntax debug ip dhcp server [events | packets]
binding
Enter this keyword to delete all entries in the binding table.
address
Enter the IP address to clear the binding entry for a single IP address.
conflicts
Enter this keyword to delete all of the log entries created for IP address
conflicts.
server statistics
Enter this keyword to clear all the server counter information.
Version 8.2.1.0 Introduced on C-Series and S-Series.
unique-identifier
Enter the client identifier for a Microsoft.
Version 8.2.1.0 Introduced on C-Series and S-Series.