Dell Force10 TeraScale C Series, Reference Manual

Page: 1579 / 1640

S-Series Debugging and Diagnostics | 1579
None
Command Mode
BUFFER PROFILE
Usage
Information
If you attempt to apply a buffer profile to a non-existent port-pipe, FTOS displays the following
message. However, the configuration still appears in the running-config.
%DIFFSERV-2-DSA_BUFF_CARVING_INVALID_PORT_SET: Invalid FP port-set 2 for linecard 2.
Valid range of port-set is <0-1>
Usage
Information
When you remove a buffer-profile using the command
no buffer-profile
[
fp
|
csf
] from
CONFIGURATION mode, the buffer-profile name still appears in the output of
show buffer-profile
[
detail
|
summary
]. After a line card reset, the buffer profile correctly returns to the default values,
but the profile name remains. Remove it from the show
buffer-profile
[
detail
|
summary
]
command output by entering
no buffer
[
fp-uplink
|
csf
]
linecard port-set buffer-policy
from
CONFIGURATION mode and
no buffer-policy
from INTERFACE mode.
Command
History
H
Related
Commands
buffer-profile (Configuration)
c s
Create a buffer profile that can be applied to an interface.
Syntax buffer-profile {{ fp | csf } profile-name | global { 1Q | 4Q }
Parameters
Defaults
global 4Q
Command Mode
CONFIGURATION
linecard slot
Enter the keyword
linecard
followed by the line card slot number.
port-set port-pipe
Enter the keyword
port-set
followed by the port-pipe number.
Range: 0-3 on C-Series, 0-1 on S-Series
buffer-policy
buffer-profile
Enter the keyword
buffer-policy
followed by the name of a buffer profile
you created.
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
buffer-profile (Configuration) Create a buffer profile that can be applied to an interface.
fp Enter this keyword to create a buffer profile for the Field Processor.
csf Enter this keyword to create a buffer profile for the Switch Fabric Processor.
profile-name Create a name for the buffer profile.
global Apply one of two pre-defined buffer profiles to all of the port-pipes in the
system.
1Q Enter this keyword to choose a pre-defined buffer profile for single queue
(i.e non-QoS) applications.
4Q Enter this keyword to choose a pre-defined buffer profile for four queue (i.e
QoS) applications.