Dell Force10 TeraScale C Series, Reference Manual

Page: 1386 / 1640

1386 | SONET
www.dell.com | support.dell.com
Parameters
Command Modes EXEC Privilege
Usage
Information
If you enter debug ppp without parameters, all parameters are enabled.
delay triggers
e
Delay triggering the line or path alarms with a 100ms delay.
Syntax delay triggers { line [lrdi | sd-ber | sf-ber] | path [pais | prdi] }
To disable delay trigger (the default), enter no delay triggers { line [lrdi | sd-ber | sf-ber] | path
[pais | prdi] } command.
Parameters
Defaults Disabled
Command Modes INTERFACE
Command
History
Usage
Information
By default, certain alarms (LOS, LOF, LAIS, PLOP) bring the line protocol down immediately. Use
this command, with the
line
option, to delay that trigger event by 100ms.
By default, path alarms (AIS, RDI, LOP) do not cause (or trigger) the interface line protocol to go
down. This command, with the
path
option, can be used to trigger this action with a delay of 100ms.
authentication
(OPTIONAL) Enter the keyword
authentication
to display PPP authentication
exchanges (Challenge Authentication Protocol (CHAP) packet exchanges and
Password Authentication Protocol (PAP) exchanges) and traffic.
error
(OPTIONAL) Enter the keyword
error
to display PPP error statistics and protocol
errors.
negotiation
(OPTIONAL) Enter the keyword
negotiation
to display PPP settings negotiated
at startup.
packet
(OPTIONAL) Enter the keyword
packet
to display low-level packet dumps.
interface sonet
slot
/
port
Enter the keywords
interface sonet
followed by the slot and port information.
line
Enter the keyword
line
to delay the specified line alarm.
lrdi
(OPTIONAL) Enter the keyword
lrdi
to specify line remote defect
indicator.
sd-ber
(OPTIONAL) Enter the keyword
sd-ber
to specify signal degradation
BER errors.
sf-ber
(OPTIONAL) Enter the keyword
sf-ber
to specify signal failure BER
errors.
path
Enter the keyword
path
to delay the specified path alarm.
pais
(OPTIONAL) Enter the keyword
pais
to specify path alarm indication
signal.
prdi
(OPTIONAL) Enter the keyword
prdi
to specify the path remote defect
indication.
Version 7.4.2.0 Added path option