Dell Force10 TeraScale C Series, Reference Manual

Page: 1246 / 1640

1246 | Router Information Protocol (RIP)
www.dell.com | support.dell.com
Usage
Information
This command is intended for low-speed interfaces.
passive-interface
c e s
Suppress routing updates on a specified interface.
Syntax passive-interface interface
To delete a passive interface, use the
no passive-interface interface
command.
Parameters
Defaults Not configured.
Command Modes ROUTER RIP
Command
History
Usage
Information
Although the passive interface will neither send nor receive routing updates, the network on that
interface will still be included in RIP updates sent via other interfaces.
Related
Commands
redistribute
c e s
Redistribute information from other routing instances.
Syntax redistribute
{
connected
|
static
}
To disable redistribution, use the
no redistribute
{
connected
|
static
} command.
interface
Enter the following information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed
by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel
followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a SONET interface, enter the keyword
sonet
followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN, enter the keyword
vlan
followed by a number from 1 to 4094.
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
neighbor Enable RIP for a specified network.
network Define a neighbor.