Figure 92. Installing the custom bracket with three screws
Next steps
1.
2. Follow the procedure listed in
After working inside your system
.
Removing the GPU riser module
The procedures to remove left and right GPU riser modules are similar.
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in
Before working inside your system
3.
.
4.
Remove the cooling fan cage assembly
.
5. Disconnect the GPU power and signal cables from the system board.
6. Disconnect
from the system board.
7.
remove the rear mounting front PERC module
.
8. If installed, remove the NVLink sponges.
Steps
1. Press the blue button on the GPU riser module, lift handle comes out of GPU riser module.
2. Use both hands, in one hand hold the lift handle, and in other hold the lifting edges to remove GPU riser module out of the
system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
88
Installing and removing system components
