Dell EMC ScaleIO Ready Node 14G, Hardware Installation Manual

Page: 82 / 86

Table 18 Management network cabling (continued)
Customer Provided Management Switch
Source Destination
Node 17 BMC (iDRAC) Management Switch Port 29
Node 17 NIC 1 Management Switch Port 31
Data Network Switch A <...> Port Management Switch Port 45
Data Network Switch B <...> Port Management Switch Port 46
Data Network Switch A Mgmt Port Management Switch Port 47
Data Network Switch B Mgmt Port Management Switch Port 48
Management Server NIC 1 Management Switch Port 38
Link to Core Switch or 2nd Rack Management
Switch
Management Switch Port 52
Data network A wiring for 2U1N configuration
Use the following figure and table to connect the data network A cables.
Note
In this example, data switch ports have been intentionally left empty. These empty
ports can be used for other user-allocated purposes. If no other use is required for the
empty ports, nodes may be connected to the data switches without leaving empty
ports. However, ensure that on each node, each NIC is connected to a different data
switch (either Data Switch A or Data Switch B), in order to prevent a single point of
failure in case a switch fails.
Wiring Diagrams for a 2U1N Configuration
82 Hardware Installation Guide