Figure 108. Installing the IDSDM module
Next steps
1.
.
NOTE:
Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
2.
.
3. Follow the procedure listed in the
After working inside your system
on page 26.
Optional OCP card
Removing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the
on page 25.
2. Follow the procedure listed in
Before working inside your system
3.
Remove the expansion card riser
.
Steps
1. Open the blue latch to unlock the OCP card.
2. Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
3. Slide the OCP card out of the slot on the system.
106
Installing and removing system components
