Dell EMC PowerEdge R250, Installation And Service Manual

Page: 61 / 90

Installing the IDSDM module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions .
2. Follow the procedure listed in the Before working inside your system .
3. Remove the air shroud .
Steps
1. Locate the IDSDM connector on the system board.
To locate IDSDM, see the System board jumpers and connectors section.
2. Align and insert the IDSDM module into the connector on the system board, until it is firmly seated.
3. Push IDSDM module until it is firmly seated in the connector on the system board.
Figure 58. Installing the IDSDM module
Next steps
1. Install the MicroSD cards .
NOTE: Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
2. Install the air shroud .
3. Follow the procedure listed in the After working inside the system .
MicroSD card
Removing the Micro-SD card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions .
2. Follow the procedure listed in the Before working inside your system .
3. Remove the air shroud .
Installing and removing system components 61