Figure 87. Installing the system battery
Next steps
1.
.
2. Follow the procedure listed in the
After working inside your sled
section.
3. While booting, press F2 to enter the
System Setup
and ensure that the battery is operating properly.
4. Enter the correct time and date in the
System Setup
Time
and
Date
fields.
5. Exit the
System Setup
.
System board
A system board (also known as the motherboard) is the main printed circuit board in the system with different connectors used
to connect different components or peripherals of the system. A system board provides the electrical connections to the
components in the system to communicate.
Removing the system board
Prerequisites
CAUTION:
If you are using the Trusted Platform Module (TPM) with an encryption key, you may be prompted to
create a recovery key during program or System Setup. Be sure to create and safely store this recovery key. If
you replace this system board, you must supply the recovery key when you restart your sled or program before
you can access the encrypted data on your drives.
CAUTION:
If either the system board or iDRAC card fails, it is required to replace the system board and iDRAC
card simultaneously.
NOTE:
It is required to reactivate the licenses after the system board replacement.
CAUTION:
You may find the CMOS battery loss or CMOS checksum error displayed during the first instance of
powering on the system after the processor or system board replacement which is expected. To fix this, simply
go to setup option to configure the system settings.
CAUTION:
Do not attempt to remove the TPM plug-in module from the system board. Once the TPM plug-in
module is installed, it is cryptographically bound to that specific system board. Any attempt to remove an
installed TPM plug-in module breaks the cryptographic binding, and it cannot be re-installed or installed on
another system board.
1. Follow the safety guidelines listed in the
section.
2. Follow the procedure listed in the
Before working inside your sled
section.
3. Remove the following:
a.
b.
c.
Air shroud from the system board
d.
Heat sink and processor module
e. Processor blanks, if installed.
CAUTION:
To prevent damage to the processor socket when replacing a faulty system board, ensure that
you cover the processor socket with the processor dust cover.
f.
Installing and removing sled components
93
